Metso states: “Operational uptime plays a key role in today’s crushing operations, where maximising productivity and reducing the cost per tonne are paramount.” To meet these challenges, the company has developed its new Orange Series Rotor for vertical shaft impact (VSI) crushers. With the new rotors, Metso states that productive uptime can be increased substantially through longer parts lifetime and faster service. Barmac VSIs are widely used in mines, especially as tertiary or quaternary stage crushers.
The new Metso Orange Series Rotor components have been reconfigured with a built-in possibility for easy interchange and maximising of wear life. The change-out of primary components through the service door has also been improved. “With the Orange rotors, maintenance is made easy by reducing the total number of wear parts by 30% and the total number of components by 25%. This is achieved by integrating several components and using less fixing points. Hard-facing during maintenance is no longer required.”
Tuomas Takalo, Metso’s Product Manager for Barmac VSI crushers, describes the increase in wear parts life achieved with the Orange rotor as significant: “We have tested the new primary components in real quarry operations, achieving in most cases greatly enhanced wear life. For example, the tip life was increased by 30-50%. In quarry operations, the extended lifetime will provide the operator significantly increased operational uptime. Fewer intervals between wear parts changes will clearly increase the total capacities produced.”
The change-out of primary components for the Orange rotor through the service door has been improved greatly. “In tip and cavity wear plates replacement, the actual servicing time can be cut by more than half, due to simplified retaining bar fixing,” says Takalo. According to him, similar time savings can be achieved with other wear parts replacements.
The Orange Series Rotor was designed with the operators of the older models of Barmac VSI crushers in mind. The Orange Series Rotor can be fitted, without any modifications, to all VSI models that accept the following rotors: 690 DTR, 840DTR and 990DTR.